Drag Bar-stuur, alu

Naar Rizoma merkshop

Ervaar de perfectie van Rizoma

Duik in de wereld van Rizoma, waar design en functionaliteit elkaar ontmoeten. Exclusieve producten combineren Italiaans design met de modernste technologie en stellen nieuwe normen op het gebied van stijl en prestaties. Elk stuk is een meesterwerk dat met de grootste precisie en aandacht voor detail is gemaakt. Rizoma tilt jou en je motor naar een nieuw niveau - het merk staat voor kwaliteit, innovatie en ongeëvenaarde esthetiek. Ontdek de collectie nu en til je rijervaring naar een hoger niveau. Ervaar de exclusiviteit die alleen Rizoma kan bieden en geniet van het onmiskenbare design waarmee je je kunt onderscheiden.

Rizoma – Enhancing beauty

Made in Italy

This product is made of high-quality aluminium and will look great on your motorbike. To ensure that it gives you years of pleasure, please observe the following instructions: To keep this product in top condition, it should be treated after long trips in winter, or in rain or salty air (near the coast), and also at periodic intervals.

Water and salt encourage corrosion. After cleaning (e.g. with Procycle Special Gel Cleaner, Order no. 10004909), we recommend regularly polishing aluminium parts with standard aluminium polish (e.g. Alu-Magic, Order no. 10004031).

Technical accessories whose operational safety depends not only on their own strength and function, but also on proper installation on the vehicle, are often supplied with a TÜV (German Technical Inspection Association) certificate. The user is obliged to have such accessories immediately registered in the vehicle papers by a TÜV test centre. This also involves the TÜV inspector checking the vehicle's operational safety. A charge is made for such registration.
Today, TÜV reports are increasingly issued for specific types of vehicle. However, no manufacturer is able (e.g. for cost reasons) to have their products tested on all vehicles which might use them. If a vehicle model is not listed, it is the inspector who has to decide about registration on the basis of his technical expertise; the strength of the product and its roadworthiness are confirmed by the existing TÜV report.
Since 2002, TÜV only accepts component certificates which include verification of the manufacturer's quality management system according to the requirements of §19 Appendix XIX of the German Road Traffic Licensing Regulations (StVZO) in the form of a valid certification document. Older reports can now only be used in exceptional circumstances in the course of a full technical inspection (Bauratabnahme), but the inspector is by no means obliged to make the entry in the papers.